CS-874 one component room temperature curing silicone rubber series
Product classification：Silicone sealant for solar panel
Product Profile：Product Name: CS & ndash; 874 single component room temperature curing silicone rubber series
Model: CS & ndash; 874
Appearance: translucent paste / no flow
Specification: 30 aluminum tubes (80g / tube); 310ML / tube (300g / tube)
Hardness (Shore A): 20-30
Thermal conductivity [w (M & middot; K)]:----
Order Hotline： 0755-27103658 Immediate consultation
* clean the surface to be constructed, cut off the top of the sharp mouth and seal it according to the dosage, install it on the packaging mouth, apply it on the construction surface, and put it in the air. The surface of the product can lose its adhesion (surface dry) within 10-30 minutes at room temperature, and fully cure within 8-24 hours. The heating of the product can not obviously change its curing speed.
* Unused rubber materials shall be sealed for storage. The storage period is 6 months (25 ℃).
* this product is not dangerous, but it is not allowed to enter or eyes.
* transportation: no domestic (cn-gb), International (IMO, IATA, UN) regulations. Non dangerous goods.
Operating performance: ① surface skinning time (min, 25 ℃): 10-30 & nbsp; ② curing time (min, 25 ℃): 8-48 hours (3-5mm) & nbsp; ③ curing time (min, 80 ℃)
After curing: ① hardness (Shore A): 20-30 & nbsp; ② thermal conductivity [w (M & middot; K)] & nbsp; ③ dielectric strength (kV / mm): & Ge; 18-25 & nbsp; ④ dielectric constant (100MHz): 2.55
&Nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; ⑤ volume resistivity (& omega; & middot; cm): & Ge; 2.5 & times; 1014 & nbsp; ⑥ elongation at break (%): 130-170 & nbsp; ⑦ dissipation factor (100Hz): 0.0022
&Nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; ⑧ service temperature range (℃): - 55 ℃ - 250 ℃ & nbsp; ⑨ flame retardant grade: 94v1-94v0
* this product is a single component organosilicon compound, which is a translucent paste.
* this product has good high and low temperature resistance, earthquake resistance, flame retardant, corona resistance, leakage resistance, insulation, corrosion resistance, weather resistance and other characteristics. After curing, the colloid can be used in a wide temperature range.
* no shrinkage during curing, good waterproof, moisture-proof and insulation performance.
* meet the requirements of EU ROHS directive.